Many customers ask us a question:
How to begin with my 3d work?
1): 3D lenticular software 
2):Plastic lenticular lens
3): offset machine :offset printing or inkjet printing
Different ways of printing:
offset/UV flatbed/inkjet printing 
4): Laminator/Double-sided adhesive 
It helps you click printed paper on the lenticular sheet,if print directly,no need.
That is all.
if have any other questions,pls feel free to contact us.Email:3d@lenticular.mobi

Material:PS plastic

Lenticular Sheet,Lenticular Mould design 3D Lenticular Folder

Lenticular Korea,Lenticular Russia LenticularLenticular

Viewing Angel:40degree

Lenticular Sheet,Lenticular Mould design 3D Lenticular Folder

Lenticular Relevant:

Post-guide to graphic mounting

Photo mounting depends on the stability of the machine itself on one hand, but more importantly lies in the user's operating skills. In view of  the general use of simple cold mounting machine, we introduce several methods of operation for your reference:
1.Wiping the grating plate with a clean cloth and cutting a double-sided adhesive tape (double-sided adhesive tape is larger than the grating sheet). Turning the pressure-regulating handle of the boxes on both sides of the machine, then separating the upper axle from the lower axle and placing the grating and double-sided adhesive into the two rollers in-between (the double-sided adhesive is put on the smooth side of lenticular lens  sheet, if the two sides is transparent, then omit this step), rotating the pressure-handle to moving down the upper axle parallelly until the regulator handle is very tightly (Note: the pressure must be balanced,  otherwise it easily leads to bubbles. The pressure should be medium, if too big or too small, problems will come).
2. After adjusting the pressure well, we turn cold mounting roller to make this side close to the operation a little spare space, then picking up the double-sided adhesive and folding down isolation paper or film, and film encases cold mounted roller and (focus) rotate it to make this part adhesive to the grating. Making the sticky side in front and pressing into the two rollers in -between of the cold mounted machine. Picking up the double-sided adhesive paper to tear away all of the remaining isolation paper. Adhesive film encase cold mounted roller (focus), turning rollers of cold mounting  (try not to stop in the middle). Thus this side is mounted well, with the blade to cut the abundant part. The other side is mounted well like that.
3. Putting the picture on the table and cutting a small portion of the isolation film on the grating sheet (attention: not too much). Covering the paintings with grating sheet, closing one eye with one hand pulling thelenticular lens until the objects in the picture moving left and right as a whole, rather than up and down or sub-section . (if the picture need to be installed into the frame, just hit  the black lines on the edge of the screen). Press tightly and do not let the lenticular lens move, put down that part of thelenticular lens without membrane and stick well (first stick to the middle, then drive to the sides from up - down). That sticky side is in front and press it into the two rollers in-between of the cold mounting machine . Pick up the grating and tear away all the remaining membrane, lenticular lens encases cold mounting roller (focus) turned cold mounting roller, thus a picture will be mounted well.

Lenticular Sheets Technology Limited2017/3/29 16:12:57

Lenticular Sheet,Lenticular Mould design 3D Lenticular Folder